|
Dalby Brass Fine Brass Architectural Fittings Jesters Head Trade Mark a Sign of Traditional English Craftsmanship |
||
|
|
|
|
|
Installation and power requirements for butlers bell driver Supply requirements 12 volts d.c. 12 watts min Internal fuse 1.25 amp
Install bell driver as per photograph above. Connect bell to driver using a suitable wire cord (T) such as picture hanging wire, placing as little resistance as possible upon the driver arm. The picture shows the driver in an inactivated position (A). B is to be the activated position thus pulling on the cord, ringing the bell. The bell driver can be mounted inverted thus allowing the bell to be mounted to the right of the driver.
Copyright Dalby Brass 2009 |
||
